User Manual

Assemble the Aircraft

Wing Installation

1. Position the wing and fuselage with the bottom side facing up.

2. Align and attach the wing to the fuselage.

3. Secure the wing to the fuselage using the 4 screws. Use two screws

(M3 x 16mm) for the front and rear holes. Use two screws (3mm x 25mm)

for the side holes.

Disassemble in reverse order.

3 x 25mm (2)

3 x 16mm (2)

Nose Gear Installation

1. Connect the nose gear assembly servo connector to the nose gear servo

extension in the fuselage. When connecting the servo connectors match

the colored wires when inserting the male servo plug in the female. Orange

is the signal wire (S), red is positive (+), brown is negative (-).

2. Install the nose gear assembly (A) into the fuselage with the air inlet facing

forward.

3. Secure the nose gear assembly using eight 2mm x 8mm screws (C).

Disassemble in reverse order.

Main Gear Installation

1. Place the aircraft inverted.

2. Insert the main gear strut (A) into the landing gear plate hole located

on the wing.

3. Carefully turn each strut in the landing gear plate until the horizontal

section (B) of the strut gently snaps into place.

Where needed, disassemble in reverse order.

2 x 8mm (8)