Turbo Timber Evolution Manual

EN
5
WARNING: Before proceeding, remove the spinner and propeller from the motor shaft. Never attempt to
program the radio components, assemble the aircraft or perform maintenance of any kind without
removing the propeller or engaging throttle cut. Serious injury could result if the motor starts inadvertently with
the propeller still attached.
Model Assembly
Mount the Spring Assemblies to the Fuselage
1. Align the spring assemblies with the mounting holes in the fuselage. These
assemblies mount to the plastic bracket pre-installed in the fuselage between
the landing gear.
2. Install the two 3 x 10mm self tapping screws to anchor the spring assemblies
in place.
Clamp the Spring Assemblies Together
1. Align the spring assemblies with the joiner bracket.
2. Clamp the assembly together with the two 2 x 6mm self tapping screws.
3 x 10mm
self-tapping
button head
2 x 6mm
self-tapping
button head
Landing Gear Installation
Mount the Landing Gear to the Fuselage
1. Insert one landing gear assembly into the pocket on the side of the fuselage
as shown. The landing gear legs mount to the flat spot of the aluminum block
which can pivot in the pocket.
2. Thread the included 3 x 8mm machine screws through the landing gear leg
into the threaded holes in the aluminum pivot block.
3. Repeat the process to install the second landing gear assembly.
3 x 8mm button
head machine