User Manual

Battery Selection

We recommend the E-ﬂ ite

2200mAh 11.1V 3S 30C Li-Po battery

(EFLB22003S30). Refer to the Optional Parts List for other recommended

batteries. If using a battery other than those listed, the battery should be within

the range of capacity, dimensions and weight of the E-ﬂ ite Li-Po battery packs

to ﬁ t in the fuselage. Be sure the model balances at the recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. It is recommended to apply hook and loop tape (A) to the bottom of your

battery.

3. Press the battery latch button (B) to remove the battery hatch.

4. Install the fully charged battery (C) in the battery compartment as shown.

See the Adjusting the Center of Gravity instructions for more information.

5. Make sure the ﬂ ight battery is secured using the hook and loop straps (D).

6. Connect the battery to the ESC (the ESC is now armed).

7. Keep the aircraft immobile on its landing gear and away from wind or the

system will not initialize.

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver.

8. Reinstall the battery hatch.

CAUTION: Always

keep hands away from

the propeller. When

armed, the motor will turn

the propeller in response

to any throttle movement.

Battery Installation and ESC Arming