User Manual

EN
9
Control Surface Centering
Control Horn and Servo Arm Settings
Factory Settings
Horns Arms
Elevator
Rudder
Ailerons
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the online Spektrum AR636
manual for adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
IMPORTANT: DO NOT use sub-trim and trim to center control surfaces. The
AS3X system requires sub-trim and trim set at 0.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the linkages to center the control surfaces.
More control throw Less control throw