User manual

Model Assembly

Landing Gear Installation

1. Install the landing gear assembly (A) on the fuselage and secure in place

using 3 screws (B).

Horizontal Stabilizer Installation

1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the

control horn faces down.

3. Secure the 2 piece horizontal tail in place with 4 pieces tape (B) included.

4. Attach the ball link (C) to the elevator control horn’s innerer most hole

using the included nut and screw.

5. Ensure the elevator and rudder servo arms are in the correct position,

then adjust the linkage to center the them.

When needed, disassemble in reverse order.