User manual

EN
8
Model Assembly Continued
3. Slide the left and right wing strut in place, between the upper and lower
wings as shown. Ensure that the logo on the strut is facing out.
4. Secure the wing struts to the top and bottom wing with the 4 included
pins (A). Ensure that the wing pins are fully seated.
5. Link the upper and lower ailerons by installing the Z-bend end (B) to the
lower wing’s aileron control horn.
6. Center the lower aileron and adjust the ball link as needed so the top
aileron is centered.
7. Secure the ball link end of the pushrod to the top wing control horn with
the included screw (C) and nut (D).
When needed, disassemble in reverse order.
A
B
C
C
Bottom wing pin fully seated
Top wing pin fully seated