User Manual

EN
Opterra
®
2m
Preight
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the ight battery.
4 Setup Transmitter using transmitter setup chart.
5 Fully assemble the airplane.
6 Install the ight battery in the aircraft (once it has been fully charged).
7 Check the Center of Gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure linkages move freely.
10 Perform the Control Direction Test with the transmitter.
11 Perform the AS3X Control Direction Test with the aircraft.
12 Adjust ight controls and transmitter.
13 Perform a radio system Range Test.
14 Find a safe open area to y.
15 Plan ight for ying eld conditions.
Transmitter Setup
IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
Program Your Transmitter
1. Start with a clean model memory slot.
2. Set the model type to “Airplane.”
3. Assign channel 5 (Gear) to a 2-position switch. In the table at right,
switch A is used.
4. Leave all other settings at the default values.
Switch A will now control the ight mode function.
• Switch position 0 = AS3X Mode
• Switch position 1 = Launch (SAFE) Mode
If, after ying the aircraft, more or less exponential or dual rate values
are desired, those may be adjusted up or down to suit your ying style.
Computerized Transmitter Setup
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9, DX18, DX20, iX12, iX20, NX6, NX8, NX10)
Start all transmitter programming with a blank ACRO model
(do a model reset), then name the model.
Set Dual Rates to:
HIGH 100%
LOW 100%
Set Servo Travel to: 100%
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Channel Assign
Channel Input Cong
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear Switch A
6 Aux 1
Frame Rate
22mz
DSMX
Funtion List
Timer
Mode Count Down
Time 8:00
Start Throttle Out
Over 25%
One Time Inhibit
4