User Manual

Model Assembly

1. Slide a winglet (A) onto each wing.

2. Secure the winglet into place using the included (smaller sized) locking pin

(B). Insert the pin and turn it 90 degrees to lock it into place.

3. Slide the front wing tube (short) (C) and back wing tube (D) into the fuse-

lage.

4. Insert the vertical n (E) into the pocket at the root of the wing (F) so the

holes align and slide it onto the back wing tube (D). The vertical ns should

angle outward.

5. Slide the wing onto the front tube.

6. Connect the elevon servo connector (G) to the servo connector located in

the wing pocket, then slide the wing assembly on the wing tubes until it

meets with the fuselage.

7. Attached the opposite vertical n and wing assembly to the fuselage by slid-

ing them onto the wing tubes.

8. Secure the left and right wing assemblies to the fuselage using the included

locking pin (H). Insert the pin and turn it 90 degrees to lock into place.

Wing Installation