User Manual

EN
13
Motor Service
Disassembly
1. Remove the spinner screw and spinner.
2. Use a tool to remove the propeller nut and then the prop
washer and prop.
3. Pull off the magnetically held cowl.
4. Remove the four 3 x 15mm self tapping screws and the
motor with the X-mount from the fuselage.
5. Disconnect the motor wires from the ESC wires.
Assembly
1. Assemble in reverse order.
• Correctly align and connect the motor wire colors with
the ESC wires.
• Install the propeller with the numbers facing out from
the motor.
• Tighten the spinner screw to secure the propeller into
place.
3 x 15 mm
Phillips head
machine
3 x 15 mm
Phillips head
self tapping
Troubleshooting Guide AS3X
Problem Possible Cause Solution
Oscillation
Damaged propeller or
spinner
Replace propeller or spinner
Imbalanced propeller Balance the propeller
Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver Align and secure receiver in fuselage
Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Worn parts Replace worn parts (especially propeller, spinner or servo)
Irregular servo movement Replace servo
Inconsistent flight
performance
Trim is not at neutral If you adjust trim more than 8 clicks, adjust the clevis to remove trim
Sub-Trim is not at neutral No Sub-Trim is allowed. Adjust the servo linkage
Aircraft was not kept
immobile for 5 seconds
after battery connection
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep
the aircraft still for 5 seconds
Incorrect
response to the
AS3X Control
Direction Test
Incorrect direction set-
tings in the receiver,
which can cause a crash
DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly
Post Flight
1. Disconnect the flight battery from the ESC (Required for Safety
and battery life).
2. Power OFF the transmitter.
3. Remove the flight battery from the aircraft.
4. Recharge the flight battery.
5. Repair or replace all damaged parts.
6. Store the flight battery apart from the aircraft and monitor the
battery charge.
7. Make note of the flight conditions and flight plan results, planning
for future flights.
CAUTION: Always disconnect the flight battery
before performing motor service.
3 x 8 mm
Cap head
3 x 6 mm
Flat head