User Manual

EN
5
Tail Installation
Horizontal Stabilizer
1. Insert the horizontal stabilizer tube into one of the stab halves.
2. Slide the halves together into the fuselage. Key the mating
elevator parts together snugly.
3. Install two 3 x 15 mm screws to secure the stab halves.
4. Insert the Z-Bend of the pushrod into the outside hole of the
elevator servo arm and press the elevator pushrod end onto the
elevator control horn ball.
Vertical Fin
5. Apply epoxy or medium/thick CA glue to the rudder hinge tabs.
Slide the hinges into the hinge slot while guiding the tail wheel
wire into the bracket. IMPORTANT: Do not get glue near the
hinge pins. Allow the glue to fully set before continuing.
6. Install the 2 x 8 mm flat head screws into the tail wire bracket
on the rudder.
7. Insert the Z-Bend into the outside hole of the rudder servo
arm and press the rudder pushrod end onto the rudder
control horn ball.
5
1
2
3
4
6
7
Model Assembly
Landing Gear Installation
1. Fit the landing gear into the slot.
2. Install the landing gear cover and secure using four 3 x
15mm screws.