User Manual

EN
7
Model Assembly Continued
The Spektrum
™
AR631 receiver is recommended for this airplane.
If you choose to install another receiver, ensure that it is at least a
4-channel full range receiver. Refer to your receiver manual for correct
installation and operation instructions.
Installation (AR631 shown)
1. Remove the magnetic bottom hatch cover.
2. Mount the receiver parallel to the length of the fuselage as shown.
Use a small piece from the included hook and loop material.
NOTICE: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate ESC and servo leads to their respective ports
on the receiver using the chart in the illustration.
4. Use the included Y-Harness to connect the two aileron servos.
Control Surface Centering
PNP Receiver Selection and Installation
After assembly and transmitter setup, bind a transmitter to the
aircraft receiver and set the trims and sub-trims to 0.
If the control surfaces are not centered, adjust the linkages by
turning the pushrod end on the linkage to change its length.
• Turn the pushrod end clockwise or counterclockwise until the
control surface is centered.
• Attach the linkage to the servo arm or control horn after
adjustment.
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder/Nose Wheel
5 = Retracts
6 = Flaps