User Manual

EN
6
V1200 Sport Airplane
Battery Installation and ESC Arming
A
B
C
The Spektrum
™
Smart 5000mAh 6S 30C Li-Po battery (SPMX50006S30) is
recommended for best performance.
Refer to the Optional Parts List for other recommended batteries. If using a
battery other than those listed, the battery should be within the range of capacity,
dimensions and weight of the Spektrum Li-Po battery pack to fit in the fuselage.
Be sure the model balances at the recommended CG before flying.
WARNING: Always keep hands away from the propeller. When armed, the
motor will turn the propeller in response to any throttle movement. If your
transmitter supports it, always engage throttle cut before approaching the aircraft
any time a battery is connected.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
transmitter, then wait 5 seconds.
2. Firmly grip the rear of the fuselage and pull the rear of the hatch (A) up to
remove the hatch from the fuselage.
3. Install the fully charged battery (B) in the middle of the battery compartment, as
shown. Secure using the two included hook and loop straps (C).
4. Connect the battery to the ESC (the ESC is now armed).
5. Keep the aircraft immobile and away from wind or the system will not initialize.
• The ESC will sound a series of tones.
• An LED will light on the receiver.
• If the ESC sounds a continuous double beep after the flight battery is
connected, recharge or replace the battery.
6. Reinstall the canopy hatch.