User Manual

EN
5
C B
A
C
B
A
WARNING: Before proceeding, remove the spinner and propeller from the motor shaft. Never attempt to
program the radio components, assemble the aircraft or perform maintenance of any kind without
removing the propeller or engaging throttle cut. Serious injury could result if the motor starts inadvertently with
the propeller still attached.
Model Assembly
D
Horizontal Stabilizer Installation
1. Insert the carbon horizontal stabilizer tube (A) through the hole in the fuselage.
2. Slide one side of the horizontal stabilizer halves onto the tube.
3. Using a #1 Phillips screwdriver, secure the horizontal stabilizer to the fuselage
with an M2 x 10mm screw (B).
4. Snap the ball link (C) onto the pre-installed ball (D) on the elevator control horn.
5. Repeat steps 2-4 for the other horizontal stabilizer half.
Control Surface Centering
After binding a transmitter to the aircraft receiver, set the trims and sub-trims to 0,
then adjust the ball links to center the control surfaces.
After assembly and transmitter setup, confirm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the control
surfaces by adjusting the linkages.
If adjustment is required, turn the ball link on the linkage to change the length of
the linkage between the servo arm and the control horn.
Wing Installation
1. Press the wing into the fuselage, ensuring the pins in the wing servo connector
plate align with the corresponding holes in the fuselage plate (A).
CAUTION: The wing servo connections should fit easily into the fuselage.
Do not force the connections together. If resistance is encountered in the
connection, check the alignment of the pins and connectors and try again.
2. Using a #1 Phillips screwdriver, install two M4 x 50mm screws (B) in the rear
wing holes. Do not overtighten.
IMPORTANT: Make sure the screws do not extend beyond the top of the blind
nuts inside the fuselage when tightened. Allowing the screws to extend beyond
the blind nuts into the battery compartment could cause damage to the battery.
3. Install two M4 x 30mm screws (C) in the front wing holes. Do not overtighten.