Carbon-Z Cub SS 2.1m Manual

ManualsBrandsE-flite ManualsAirplanesCarbon-Z Cub SS 2.1m BNF Basic with AS3X and SAFE Select

Carbon-Z Cub SS

Replacement Parts Recommended Parts

Part # Description

EFLM74501 Motor Shaft: BL50 Outrunner

EFL1025018 Motor Mount Set: Carbon-Z

EFL1045004 Stab Set: Carbon-Z Cub

EFL1045009 Wing & Stab Tube: Carbon-Z Cub

EFL1045010 Strut Set w/Hardware: Carbon-Z Cub

EFL1045011 Pushrod Set: Carbon-Z Cub

EFL1045013 Prop Shaft: Carbon-Z Cub

EFL1045014 Hdw Pack w/Ctrl Horns: Carbon-Z Cub

EFL1045025 Strut Pins and Clips: Carbon-Z Cub

EFL12401 NYA Fuselage: Carbon-Z Cub SS

EFL12402 NYA Wing Left: Carbon-Z Cub SS

EFL12403 NYA Wing Right: Carbon-Z Cub SS

EFL12405 NYA Rudder/Gear: Carbon-Z Cub SS

EFL12406 NYA Cowling: Carbon-Z Cub SS

EFL12407 NYA Hatches: Carbon-Z Cub SS

EFL12408 NYA Landing Gear: Carbon-Z Cub SS

EFL12412 NYA Tundra Tires: Carbon-Z Cub SS

EFL12415 NYA Decal Set: Carbon-Z Cub SS

EFL12421 NYA Vortex Generator:Carbon-Z Cub SS

EFL12422 NYA Wing Screws-Ant: Carbon-Z Cub SS

EFL12423 NYA Tailwheel: Carbon-Z Cub SS

EFL12424 NYA Spinner Orange: Carbon-Z Cub SS

EFLA1060B 60-Amp Pro SB Brushless ESC (V2)

EFL12425 Battery Tray

EFLM7450 "BL50 BL Outrunner Motor, 525Kv"

EFLP1570E 15 x 7 Electric Propeller

EFLR7145 26g Digital MG Mini Servo

EFLR7155 13g Digital Sub-Micro Servo

SPMAR636 AR636 6-Ch AS3X Sport Receiver

Part # Description

SPMR636 AR636 6-Ch AS3X Sport Receiver

EFLB0004S30 14.8V 5000mAh 4 S 14.8V 30c LiPo, 10AWG EC5

SPMX40006S50 22.2V 4000mAh 6S 50C Smart LiPo Battery, IC5

SPMX50006S50 22.2V 4000mAh 6S 30C Smart LiPo Battery, IC5

EFLB50005S30 18.5V 5000mAh 5S 30C LiPo, 10AWG: EC5

EFLB50005S30 22.2V 5000mAh 6S 30C LiPo, 10AWG: EC5

SPMR6650 DX6e 6 Channel transmitter Only

DYNC2015 Prophet Precept 80W Charger

SPMXC1000 Smart S1200DC Charger, 1X200W

Optional Parts

Part # Description

SPMAR636 AR636 6-Ch AS3X Sport Receiver

SPMR12000 iX12 12 Channel Transmitter Only

SPMR6750 DX6 Transmitter Only MD2 G3

SPMR8000 DX8 Transmitter Only MD2

SPMR8100 DX8e 8CH Transmitter Only

SPMR9910 DX9 Black Transmitter Only MD2

EFL12419 NYA Float Strut Set: Carbon-Z CUB

EFLA5600 Carbon-Z Float Set

APC17080E Elictric Propeller, 17 x 8E

DYNC2050 Prophet Sport 4 x 100WAC/DC Charger

EFL1045023 Camera Mount: C-Z Cub

EFL12419 NYA Float Strut Set: Carbon-Z Cub S

EFLA56000 Carbon-Z Float Set

EFLB44006S30 22.2V 4400mAh 6S 30C LiPo, 10AWG: EC5

EFLB50006S30 22.2V 5000mAh 6S 30C LiPo, 10AWG: EC5

EFLM4060A Power 60 BL Outrunner Motor, 400Kv

SPMR7350 7 Channel AS3X Receiver

Problem Possible Cause Solution

Aircraft will not

connect (after

binding) to

transmitter

Transmitter too near aircraft during connecting process

Move powered transmitter a few feet from aircraft, disconnect and reconnect

ﬂ ight battery to aircraft

Aircraft or transmitter is too close to large metal

object, wireless source or another transmitter

Move aircraft and transmitter to another location and attempt connecting again

Bind plug left installed in bind port Rebind transmitter to the aircraft and remove the bind plug before cycling power

Aircraft bound to different model memory

(ModelMatch

radios only)

Select correct model memory on transmitter

Flight battery/Transmitter battery charge is too low Replace/recharge batteries

Transmitter may have been bound to a different aircraft

using different DSM protocol

Bind aircraft to transmitter

Control surface does

not move

Control surface, control horn, linkage or servo damage Replace or repair damaged parts and adjust controls

Wire damaged or connections loose Do a check of wires and connections, connect or replace as needed

Transmitter is not bound correctly or the incorrect air-

planes was selected

Re-bind or select correct airplanes in transmitter

Flight battery charge is low Fully recharge ﬂ ight battery

BEC (Battery Elimination Circuit) of the ESC is damaged Replace ESC

Controls reversed Transmitter settings are reversed Perform the Control Direction Test and adjust the controls on transmitter appropriately

Motor power pulses

then motor loses

power

ESC uses default soft Low Voltage Cutoff (LVC) Recharge ﬂ ight battery or replace battery that is no longer performing

Weather conditions might be too cold Postpone flight until weather is warmer

Battery is old, worn out, or damaged Replace battery

Battery C rating might be too small Use recommended battery