User Manual

EN
21
Replacement Parts Recommended Parts
Part # Description
SPMX50004S30 14.8V 5000mAh 4S 30C Smart LiPo Battery, IC5
SPMX40006S50 22.2V 4000mAh 6S 50C Smart LiPo Battery, IC5
SPMX50006S50 22.2V 4000mAh 6S 30C Smart LiPo Battery, IC5
SPMX50006S30 18.5V 5000mAh 5S 30C Smart LiPo Battery, IC5
SPMX70006S30 22.2V 7000mAh 6S 30C Smart LiPo Battery, IC5
SPMR6650 DX6e 6 Channel transmitter Only
SPMXC1080 Spektrum Smart S1100 AC Charger 1x100W
SPMXC1000 Smart S1200DC Charger, 1X200W
Optional Parts
Part # Description
EFL12419 Float Strut Set: Carbon-Z CUB SS
EFLA5600 Carbon-Z Float Set
APC17080E Elictric Propeller, 17 x 8E
SPMXC1010 Smart S2100 AC Charger, 2x100W
EFL1045023 Camera Mount: C-Z Cub
EFL12419 Float Strut Set: Carbon-Z Cub SS
EFLA56000 Carbon-Z Float Set
EFLB44006S30 22.2V 4400mAh 6S 30C LiPo, 10AWG: EC5
EFLM4060A Power 60 BL Outrunner Motor, 400Kv
SPMR6750 DX6 Transmitter Only MD2 G3
SPMR8000 DX8 Transmitter Only MD2
SPMR8105 DX8e 8CH Transmitter Only
SPMR9910 DX9 Black Transmitter Only MD2
SPMR12000 iX12 12 Channel Transmitter Only
SPMR20100 iX20 20 Channel Transmitter Only
SPMR6775 NX6 6 Channel Transmitter Only
SPMR8200 NX8 8 Channel Transmitter Only
SPMR10100 NX10 10 Channel Transmitter Only
Part # Description
EFLM74501 Motor Shaft: BL50 Outrunner
EFL1025018 Motor Mount Set: Carbon-Z
EFL1045004 Stab Set: Carbon-Z Cub
EFL1045009 Wing & Stab Tube: Carbon-Z Cub
EFL1045010 Strut Set w/Hardware: Carbon-Z Cub
EFL1045011 Pushrod Set: Carbon-Z Cub
EFL1045013 Prop Shaft: Carbon-Z Cub
EFL1045014 Hardware Pack w/Ctrl Horns: Carbon-Z Cub
EFL1045025 Strut Pins and Clips: Carbon-Z Cub
EFL12401 Fuselage: Carbon-Z Cub SS
EFL12402 Wing Left: Carbon-Z Cub SS
EFL12403 Wing Right: Carbon-Z Cub SS
EFL12405 Rudder/Gear: Carbon-Z Cub SS
EFL12406 Cowling: Carbon-Z Cub SS
EFL12407 Hatches: Carbon-Z Cub SS
EFL12408 Landing Gear: Carbon-Z Cub SS
EFL12412 Tundra Tires: Carbon-Z Cub SS
EFL12415 Decal Set: Carbon-Z Cub SS
EFL12421 Vortex Generator:Carbon-Z Cub SS
EFL12422 Wing Screws-Antenna t: Carbon-Z Cub SS
EFL12423 Tailwheel: Carbon-Z Cub SS
EFL12424 Spinner Orange: Carbon-Z Cub SS
SPMXAE1060B Avian 60-Amp Brushless Smart ESC
EFL12425 Battery Tray
EFLM7450 "BL50 BL Outrunner Motor, 525Kv"
EFLP1570E 15 x 7 Electric Propeller
EFLR7145 26g Digital MG Mini Servo
EFLR7155 13g Digital Sub-Micro Servo
SPMAR637T AR637T 6 CH AS3X Telemetry RX
Problem Possible Cause Solution
Aircraft will not
connect (after
binding) to
transmitter
Transmitter too near aircraft during connecting process
Move powered transmitter a few feet from aircraft, disconnect and reconnect
ight battery to aircraft
Aircraft or transmitter is too close to large metal
object, wireless source or another transmitter
Move aircraft and transmitter to another location and attempt connecting again
Bind plug left installed in bind port Rebind transmitter to the aircraft and remove the bind plug before cycling power
Aircraft bound to different model memory
(ModelMatch
TM
radios only)
Select correct model memory on transmitter
Flight battery/Transmitter battery charge is too low Replace/recharge batteries
Transmitter may have been bound to a different aircraft
using different DSM protocol
Bind aircraft to transmitter
Control surface does
not move
Control surface, control horn, linkage or servo damage Replace or repair damaged parts and adjust controls
Wire damaged or connections loose Do a check of wires and connections, connect or replace as needed
Transmitter is not bound correctly or the incorrect air-
planes was selected
Re-bind or select correct airplanes in transmitter
Flight battery charge is low Fully recharge ight battery
BEC (Battery Elimination Circuit) of the ESC is damaged Replace ESC
Controls reversed Transmitter settings are reversed Perform the Control Direction Test and adjust the controls on transmitter appropriately
Motor power pulses
then motor loses
power
ESC uses default soft Low Voltage Cutoff (LVC) Recharge ight battery or replace battery that is no longer performing
Weather conditions might be too cold Postpone flight until weather is warmer
Battery is old, worn out, or damaged Replace battery
Battery C rating might be too small Use recommended battery