Draco Manual

Model Assembly Continued

Foot Step Installation

1. Press the right and left foot steps (A) into the slots in the fuselage with the

tab facing to the front of the aircraft.

2. Secure the right and left foot steps into place with 3 x 8mm self tapping

screws (B).

Disassemble in reverse order.

Antenna Installation

1. Apply medium CA to the base of the belly antenna (A) and press it into the

slot on the bottom of the fuselage.

2. Apply medium CA to the base of the top fuselage antenna (B) and press it

into the respective slot in the top of the fuselage.

3. Apply medium CA to the base of the wing antenna (C) and press it into the

respective slot in the right wing.

Propeller Installation

1. Remove spinner nut and washer from propeller shaft.

2. Slide the propeller (A), and washer (B) onto the motor shaft (C).

3. Install and tighten the spinner nut (D) using an adjustable wrench (13mm).

4. Slide the spinner (E) onto the shaft in front of the propeller.

5. Secure the spinner with the spinner screw M3 x 10mm (F).

Disassemble in reverse order.

3 X 8mm