User Manual

EN
DRACO 2.0m
10
Model Assembly Continued
LED Light Controller Settings and Options
1. Plug the light controller into the gear channel (Port 5). This is already done
on BNF Basic version models.
2. Assign the gear (port 5) to a rotary knob of your transmitter to give full
control of all 7 light modes.
If your transmitter doesn’t have a rotary knob option, the light module can still
function and be assigned to any 2 or 3 position switch, however not all light
modes will be available. Travel adjust and sub trim can be used to change
modes for the 2 or 3 position switch.
The light module can also be Y-harnessed with any channel like flaps but you
will only get the light groups in the position the channel is in. REMOVE
Light mode Light activated during each mode
Approximate %
travel for each
mode
Mode 1
Instrument panel light in the fuselage
(Always ON when Light Module is connected) All
other lights off.
-100 to -75
Mode 2
• Red and green navigation lights
• Wingtip strobes
• Lights on the trailing edge of rudder
-74 to -45
Mode 3
• Red and green navigation lights
• Wingtip strobes
• Lights on the trailing edge of rudder
• Flashing light on top of rudder
-44 to -15
Mode 4
• Red and green navigation lights
• Wingtip strobes
• Lights on the trailing edge of rudder
• Flashing light on top of rudder
• 45º wing light
• Wingtip landing lights
-14 to 15
Mode 5
• Red and green navigation lights
• Wingtip strobes
• Lights on the trailing edge of rudder
• Flashing light on top of rudder
• 45º wing light
• Wingtip landing lights
• Nose flashing light
• 90º down flashing wing light
16 to 45
Mode 6
• Red and green navigation lights
• Wingtip strobes
• Lights on the trailing edge of rudder
• Flashing light on top of rudder
• 45º wing light,
• Wingtip landing lights
• Nose flashing light
• 90º down flashing wing light
• Backup light
46 to 75
Mode 7
• Wingtip strobes
• Lights on the trailing edge of rudder
• 45º wing light
• Wingtip landing lights
• Backup light
76 to 100