User Manual

The recommended receiver for this aircraft is the Spektrum AR637T. If you

choose to install a different receiver, ensure that it is at least a 6-channel

full range receiver. Refer to the manual of your chosen receiver for correct

installation and operation instructions.

AR637T Installation

1. Remove the rear window of the aircraft by pulling up on the side tabs.

2. Remove the receiver hatch by pulling up on the hatch tabs, to expose the

receiver compartment.

3. Connect the appropriate control surfaces to the their respective ports on

the receiver using the table at the right.

4. Using double-sided servo tape (not included) mount the receiver to

the ﬂat area of the receiver compartment, as shown. The receiver (A)

should be mounted in the orientation shown, parallel to the length of the

fuselage, with the label facing up and the servo ports facing the rear of the

aircraft. The orientation of the receiver is critical for all AS3X

and SAFE

technology setups.

CAUTION: Incorrect installation of the receiver could cause a crash.

PNP Receiver Selection and Installation

AR637T Port

Assignments

BND/PRG = BIND

1 = Throttle

2 = Aileron

3 = Elevator

4 = Rudder

5 = Light Module

6 = Flaps