User Manual

EN
DRACO 2.0m
6
Landing Gear Installation
1. Install two 5mm ID washers (A) and one wheel onto each axle.
2. Secure the wheels in place with one 3.5mm ID washer (B) and M3 nylon
locknut (C), using a 5.5mm nut driver.
3. Install the landing gear assembly (D) on the fuselage and secure in place
using M4 x 20mm screws (E) and a #1 Philips screwdriver.
4. Remove the paper from the double sided tape and install the foam cover (F)
onto the center of the main gear assembly.
Disassemble in reverse order. The foam cover will remain attached to the
landing gear.
Model Assembly
D
M4 X 20mm (4)
E
B
A
M2 X 20mm
C
Tail Wheel Installation
1. Install the tailwheel assembly (A) with two M2 screws and M5 nylon
locknuts. The M2 x 20mm screw goes through the lower mount and
connects the tail wheel bracket. Do not over tighten. Once the nut is snug
check for free movement before attaching the shock. The M2 x 13mm
screw goes through the upper mount and connects the shock.
IMPORTANT: Do not over tighten the screws and nuts. Over tightening will
prevent the tailwheel from pivoting up and down.
2. Install the plastic covers (B) to the left and right side and secure in place
with a 3 x 6mm self tapping screw for each side.
3. Install the tailwheel springs (C) using needle nose pliers. Attach each spring
to the tail wheel assembly steering arm first, then attach the other end to
the steering arm on the fuselage.
Disassemble in reverse order.
5mm washer (2)
A
M3
lock nut
C
3.5mm washer
B
F
M2 lock nut
M2 X 13mm
3 X 6mm