User Manual

EN
7
E
Horizontal Stabilizer Installation
1. Slide the horizontal tail (A) into the slot at the rear of the fuselage until the
retaining clip clicks. Ensure the control horn and the two support struts are
facing down.
2. Snap the left and right support struts (B) onto the ball links (C).
3. Bind your receiver to the transmitter and power on the aircraft to ensure
the elevator servo is centered before adjusting and connecting the elevator
linkage.
IMPORTANT: SAFE Select must be off to check the elevator and all control
surfaces for proper neutral. If SAFE Select is ON the surface will not
be level/neutral.
4. Snap the elevator control linkage (D) on the ball link (E).
5. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center the elevator if needed.
Disassemble in reverse order.
NOTICE: Never lift or carry the aircraft by the horizontal stabilizer. Damage
to the horizontal stabilizer may occur or it may be disconnected from the
retaining clip.
A
B
C
D
Model Assembly Continued
Aileron Counterbalance and Wing Tip Guard
Installation
1. Carefully press the included wing tip guard (A) into the wing slot until it is
fully seated.
2. Carefully align the counterbalance (B) and seat it into the recess.
3. Secure the counterbalance into place with the included
2.5 x 6mm screw (C).
4. Repeat aileron counterbalance and wing tip guard installation for the
opposite wing.
Disassemble in reverse order.
A
B
2.5 X 6mm
C
Handle Installation
1. Carefully apply medium CA to the handle. Use only one or two drops to
prevent CA glue from running.
2. Carefully press the handle (A) into the recess in the wing until the handle is
fully seated.
3. Place the wing vertically while the adhesive cures.
A