User Manual

Tail Gear Installation
1. Install the tail gear springs (A) as shown.
2. Install the opposite ends of the tail gear springs to the tail gear assembly (B).
3. Secure the tail gear assembly into place using the included M3 x 30mm screw
(C) in the front hole and the M3 x 10mm screw (D) for the rear hole. Tighten
the two screws into place using a 2.0 hex wrench.
When needed, disassemble in reverse order.
EN
7
A
C
M3 x 30mm
D
M3 x 10mm
B