User Manual

EN
9
Horizontal Tail Installation
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the control
horn faces down.
3. Install two M3 x 12mm screws (B) in the holes in the bottom of the horizontal
tail. Tighten the scews using a 2.0 hex wrench.
4. Attach the ball link (C) to the elevator control horn’s outermost hole using the
included M2 lock nut (D) and M2 x 12mm screw (E). Tighten the M2 lock nut
and M2 x 12mm screw using a 5mm nut driver and a 2.0 hex wrench.
Tip: Use ball link pliers (BLH100) to remove or install a link on a control horn.
5. Ensure the elevator servo arm is in the correct position, then adjust the linkage
to center the elevator.
When needed, disassemble in reverse order.
A
B
M3 x 12mm
C
D
M2 lock nut
E
M2 x 8mm