User Manual

Lights

Bind Port

Right Flap

Left Flap

Ailerons

Night Timber X 1.2m

With the basic transmitter setup, the ailerons and  aps will operate separately.

For increased aileron authority, the AR637TA receiver included in the BNF

version may be con gured so the  aps can operate as both  aps and ailerons.

Servo Plug Order Change

1. Remove the Y-harnessed lights from Ch-5 port on the AR637TA

2. Remove the Y-harness plugged into the Ch-6 port on the AR637TA.

3. Insert two servo extensions (EFLREX9L) into the receiver ports; one in Ch-5

and one in Ch-6.

4. The left  ap plugs into the Ch-5 extension. The right  ap plugs into the

Ch-6 extension. We recommend labeling the wires to help identify the

correct ports when mounting the wing.

5. Insert the Y-harness into the BIND port. The lights plug into one side of the

Y-harness, and the other side serves as a BIND port.

CAUTION: Connecting servos to the wrong port on the receiver could

cause a crash.

IMPORTANT: A 7-channel or higher transmitter is required for the advanced BNF

receiver setup plus the ability to select between AS3X and SAFE with SAFE Select. If

using a 6 channel transmitter for the advanced receiver setup, only AS3X is available.

BNF advanced receiver setup (optional)

AR637TA advanced receiver setup port assignments

BND/PRG = Y-Harness: Lights/BIND

1 = Throttle

2 = Y-harness: Ailerons

3 = Elevator

4 = Rudder

5 = Left  ap

6 = Right  ap

Float Installation

1. Align and mount the  oat set assembly to the bottom of the fuselage.

2. Secure the back section of the  oats to the fuselage using the included

bracket (F) and 2 screws (G).

3. Secure the front section of the  oats using the two included screws (H) to

secure the front support members to the bottom of the fuselage.

4. Attach the included wire from each  oat rudder (I) to the pull–pull horn (J)

using the two included pins (K).

Disassemble in reverse order.