User Manual

Model Assembly

Landing Gear Installation

1. Install the landing gear with the two included 3mm x 8mm

screws.

Air Tractor 1.5m

Preﬂ ight

SAFE

Select Technology (BNF Basic)

The BNF Basic version of this airplane includes SAFE Select technology which

can offer an extra level of protection in ﬂ ight. Use the following instructions to

make the SAFE Select system active and assign it to a switch. When enabled,

SAFE Select prevents the airplane from banking or pitching past predetermined

limits, and automatic self-leveling keeps the airplane ﬂ ying in a straight and

level attitude when the aileron, elevator and rudder sticks are at neutral.

SAFE Select is enabled or disabled during the bind process. When the airplane

is bound with SAFE Select enabled, a switch can be assigned to toggle

between SAFE Select mode and AS3X mode. AS3X

technology remains active

with no banking limits or self leveling any time SAFE Select is disabled or OFF.

SAFE Select can be conﬁ gured three ways;

• SAFE Select Off: Always in AS3X mode

• SAFE Select On with no switch assigned: Always in SAFE Select mode

• SAFE Select On with a switch assigned: Switch toggles between SAFE

Select mode and AS3X mode

1. Remove and inspect contents.

2. Read this instruction manual thoroughly.

3. Charge the ﬂ ight battery.

4. Setup Transmitter using transmitter setup chart.

5. Fully assemble the airplane.

6. Install the ﬂ ight battery in the aircraft (once it has been fully charged).

7. Check the Center of Gravity (CG).

8. Bind the aircraft to your transmitter.

9. Make sure linkages move freely.

10. Test the ﬂ ap operation.

11. Perform the Control Direction Test with the transmitter.

12. Perform the AS3X Control Direction Test with the aircraft.

13. Adjust ﬂ ight controls and transmitter.

14. Perform a radio system Range Test.

15. Find a safe open area to ﬂ y.

16. Plan ﬂ ight for ﬂ ying ﬁ eld conditions.