User Manual

EN
Model Assembly
Landing Gear Installation
1. Install the landing gear with the two included 3mm x 8mm screws. 2. Install the tail wheel assembly with the two 3 x 8mm screws.
3. Connect the springs between the rudder and tail wheel assembly.
4
Air Tractor 1.5m
Preflight
SAFE
®
Select Technology (BNF Basic)
The BNF Basic version of this airplane includes SAFE Select technology which
can offer an extra level of protection in flight. Use the following instructions to
make the SAFE Select system active and assign it to a switch. When enabled,
SAFE Select prevents the airplane from banking or pitching past predetermined
limits, and automatic self-leveling keeps the airplane flying in a straight and
level attitude when the aileron, elevator and rudder sticks are at neutral.
SAFE Select is enabled or disabled during the bind process. When the airplane
is bound with SAFE Select enabled, a switch can be assigned to toggle
between SAFE Select mode and AS3X mode. AS3X
®
technology remains active
with no banking limits or self leveling any time SAFE Select is disabled or OFF.
SAFE Select can be configured three ways;
• SAFE Select Off: Always in AS3X mode
• SAFE Select On with no switch assigned: Always in SAFE Select mode
• SAFE Select On with a switch assigned: Switch toggles between SAFE
Select mode and AS3X mode
1. Remove and inspect contents.
2. Read this instruction manual thoroughly.
3. Charge the flight battery.
4. Setup Transmitter using transmitter setup chart.
5. Fully assemble the airplane.
6. Install the flight battery in the aircraft (once it has been fully charged).
7. Check the Center of Gravity (CG).
8. Bind the aircraft to your transmitter.
9. Make sure linkages move freely.
10. Test the flap operation.
11. Perform the Control Direction Test with the transmitter.
12. Perform the AS3X Control Direction Test with the aircraft.
13. Adjust flight controls and transmitter.
14. Perform a radio system Range Test.
15. Find a safe open area to fly.
16. Plan flight for flying field conditions.