T-28 Trojan 1.2m Manual

WARNING: Assemble the aircraft, program your radio control system, bind the aircraft, and verify correct

operation before installing the propeller. Never attempt to program the radio components, assemble the

aircraft or perform maintenance of any kind without removing the propeller or engaging throttle cut. Serious injury

could result if the motor starts inadvertently with the propeller still attached.

Model Assembly

Horizontal Stabilizer Installation

1. Slide the horizontal stabilizer joiner into the hole in the rear of the fuselage.

2. Flex each of the elevators up and down several times to ensure the hinge allows

the elevators to move freely.

3. Install the two piece (left and right) horizontal stabilizer as shown. Ensure the

control horn faces down.

4. Secure the horizontal stabilizer pieces in place using the two included 3 x 12 mm self

tapping screws (Pack C).

3 x 12mm

self-tapping

counter sunk