Scan the QR code and select the Manuals and Support quick links from the product page for the most up-to-date manual information. Scannen Sie den QR-Code und wählen Sie auf der Produktseite die Quicklinks Handbücher und Unterstützung, um die aktuellsten Informationen zu Handbücher. Scannez le code QR et sélectionnez les liens rapides Manuals and Support sur la page du produit pour obtenir les informations les plus récentes sur le manuel.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com or towerhobbies.com and click on the support or resources tab for this product.
EN Included / Recommended Equipment Motor: BL15 Brushless Outrunner 850Kv 14 Pole Motor (EFLM4115) Installed Installed ESC: Avian 70A Smart Lite Brushless (SPMXAE70) Installed Installed Servo: Aileron (2), Flap (2), Elevator (1), and Rudder (1) 9 gram servo (SPMSA330) Installed Installed Receiver: Spektrum™ AR631 DSMX 6-Channel AS3X and SAFE Receiver (SPMAR631) Required to Complete Installed Recommended Battery: 14.
EN Transmitter Setup BNF IMPORTANT: After you set up your model, always rebind the transmitter and receiver to set the desired failsafe positions. Dual Rates Make your first flights in low rate. For landings, use high rate elevator. NOTICE: To ensure AS3X technology functions properly, do not lower rate values below 50%.
EN Receiver Selection and Installation PNP The recommended receiver for this aircraft is the Spektrum AR631. If you choose to install a different receiver, it needs to be a 4-channel or more full range (sport) receiver. Refer to the manual of your chosen receiver for correct installation and operation instructions. AR631 Port Assignments 1 = Throttle 2 = Ailerons 3 = Elevator 4 = Rudder 5 = Retracts 6 = Flaps AR631 Installation 1.
EN Assemble the Aircraft Horizontal Tail Installation 1. Slide the horizontal tail (A) into the slot in the rear of the fuselage. Ensure the control horn faces down. 2. With a 2mm Allen driver, secure the horizontal tail piece in place using the included M3 x 26 countersunk machine screw (B). Use caution to avoid over-tightening the screw. 3. Attach the clevis to the elevator control horn (see instructions for clevis connection). A B Tail wheel Elevator Flaps Clevis Installation 1. 2. 3. 4.
EN Assemble the Aircraft Wing Installation 1. Remove the canopy hatch. 2. Guide the flap, retract and aileron servo connectors (A) through the hole (B) located in the bottom of the fuselage as shown. TIP: If needed, use hemostats or pliers to pull the servo connectors into the fuselage. 3. Plug in the Y-harnesses into the receiver. The single connector side of the Y-harnesses are marked Ail, Gear, and Flap.
EN Assemble the Aircraft Propeller Installation IMPORTANT: Install the propeller after all system setups are complete to reduce the chance of accidental injury. 1. Install back side of propeller hub (A), propeller (B), and front side propeller hub (C) onto the motor shaft (D). The propeller size numbers (10.5 x 8) must face forward for correct propeller operation. 2. Install the spinner nut (E) to secure the propeller into place.
EN Center of Gravity (CG) After installing the battery (in the recommended position) and before powering on the ESC, verify the CG. The CG location starting point is 73mm (range: 73mm±3mm) behind the leading edge, as shown. 3S 2200mAh Smart battery CG position – The battery is installed all the way forward in battery compartment. Only the front battery strap will be used. 4S 3200mAh Smart battery CG position – The battery is installed centered in the battery tray, using both front and rear battery straps.
EN Flight Battery Installation and Electronic Speed Control (ESC) Arming Battery Selection A We recommend the Spektrum™ 2200mAh 14.8V 4S 30C Li-Po battery (SPMX22004S30). Refer to the Optional Parts List for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dimensions and weight of the Spektrum Li-Po battery packs to fit in the fuselage. Be sure the model balances at the recommended CG. 1.
EN General Binding Tips and Failsafe BNF • The included receiver has been specifically programmed for operation of this aircraft. Refer to the receiver manual for correct setup if the receiver is replaced. • Keep away from large metal objects while binding. • Do not point the transmitter’s antenna directly at the receiver while binding. • The orange LED on the receiver will flash rapidly when the receiver enters bind mode.
EN SAFE® Select Switch Designation BNF Once SAFE Select is enabled, you can choose to fly in SAFE mode full-time, or assign a switch. Any switch on any channel between 5 and 9 can be used on your transmitter. If the aircraft is bound with SAFE Select disabled, the aircraft will be in AS3X mode exclusively. CAUTION: Keep all body parts well clear of the propeller and keep the aircraft securely restrained in case of accidental throttle activation.
EN In Flight Trimming BNF During your first flight, trim the aircraft for your flying style in AS3X flight mode. Flight trim is usually performed between 70–100% power setting, per your preference. Make small trim adjustments with your transmitter’s trim switches to straighten the aircraft’s flight path. 3 Seconds After adjusting the trim, do not touch the control sticks for 3 seconds. This allows the receiver to learn the correct settings to optimize AS3X performance.
EN Factory Settings for the Control Horns and Servo Arms Flaps The table to the right shows the factory settings for the control horns and servo arms. Fly the aircraft at factory settings before making changes.
EN Troubleshooting Guide Problem Aircraft will not respond to throttle but responds to other controls Extra propeller noise or extra vibration Reduced flight time or aircraft underpowered Aircraft will not Bind (during binding) to transmitter Aircraft will not connect (after binding) to transmitter Possible Cause Throttle not at idle and/or throttle trim too high Reset controls with throttle stick and throttle trim at lowest setting Throttle servo travel is lower than 100% Make sure throttle servo
EN 16 Replacement Parts Recommended Parts Part # Part # Description Description EFL1228 Motor X-Mount SPMR6775 NX6 6 CH DSMX Transmitter Only EFL18501 Fuselage with Hatch SPMX22004S30 14.8V 2200mAh 4S 30C Smart LiPo Battery: IC3 EFL18502 Wing: F4U-4 1.2m SPMXC1080 Spektrum Smart S1100 AC Charger 1x100W EFL18506 Decal Sheet: F4U-4 1.2m EFL8503 Horizontal Stabilizer: F4U-4 1.2m Optional Parts EFL8504 Hatch with Pilot: F4U-4 1.
EN Important Federal Aviation Administration (FAA) Information Use the QR code below to learn more about the Recreational UAS Safety Test (TRUST), as was introduced by the 2018 FAA Reauthorization Bill. This free test is required by the FAA for all recreational flyers in the United States. The completed certificate must be presented upon request by any FAA or law enforcement official. If your model aircraft weighs more than .
EN Limited Warranty What this Warranty Covers—Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
EN Contact Information Country of Purchase Horizon Hobby Horizon Service Center (Repairs and Repair Requests) United States of America Horizon Product Support (Product Technical Assistance) Sales European Union Horizon Technischer Service Sales: Horizon Hobby GmbH Contact Information servicecenter.horizonhobby.com/RequestForm/ productsupport@horizonhobby.com 877-504-0233 websales@horizonhobby.com 800-338-4639 service@horizonhobby.
DE HINWEIS Alle Anweisungen, Garantien und andere Begleitdokumente können von Horizon Hobby, LLC nach eigenem Ermessen geändert werden. Um aktuelle Produktinformationen zu erhalten, besuchen Sie http://www.horizonhobby.com oder towerhobbies.com und klicken Sie auf die Registerkarte Support oder Ressourcen für dieses Produkt.
DE Enthaltene/Empfohlene Ausrüstung Motor: BL15 Bürstenloser Außenläufer, 850 Kv, 14-poliger Motor (EFLM4115) Eingebaut Eingebaut Geschwindigkeitsregler: Avian 70A Smart Lite bürstenlos (SPMXAE70) Eingebaut Eingebaut Servo: Querruder (2), Klappe (2), Höhenruder (1) und Seitenruder (1) 9 Gramm Servo (SPMSA330) Eingebaut Installed Empfänger: Spektrum™ AR631 DSMX 6-Kanal AS3X und SAFE-Empfänger (SPMAR631) Erforderliche Installed Empfohlener Akku: 14,8V 4S 2200mAh 30C LiPo (SPMX22004S30) Erforderl
©2022 Horizon Hobby, LLC. E-flite, Plug-N-Play, Bind-N-Fly, BNF, the BNF logo, DSM, DSM2, DSMX, Spektrum AirWare, EC3, IC3, AS3X, SAFE, the SAFE logo, ModelMatch, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks and logos are property of their respective owners. US 8,672,726 US 9,056,667 US 9,753,457. US 10,078,329. US 9,930,567. US 10,419,970.
