User Manual

EN
F4U-4 Corsair 1.2m BNF Basic
4
IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
Dual Rates
Make your rst ights in low rate. For landings, use high rate elevator.
NOTICE: To ensure AS3X technology functions properly, do not lower rate
values below 50%. If less control deflection is desired, manually adjust the
position of the pushrods on the servo arm
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting
Guide for more information.
Exponential
After first flights, you may adjust exponential in your transmitter.
†
Some of the terminology and function locations used in the iX12 and iX20
programming may be slightly different than other Spektrum AirWare
™
radios. The names given in parentheses correspond to the iX12 and iX20
programming terminology. Consult your transmitter manual for specific
information about programming your transmitter.
Transmitter Setup BNF
Computerized Transmitter Setup
(DX6i, DX6, DX7, DX7S, DX8, DX9, DX10t and DX18)
Start all transmitter programming with a blank ACRO model
(do a model reset), then name the model.
Set Dual Rates to:
HIGH 100%
LOW 70%
Set Servo Travel to: 100%
DX6i
1. Go to the SETUP LIST MENU
2. Set MODEL TYPE: ACRO
3. Go to ADJUST LIST MENU
4. Set FLAPS: Norm q100 Flap
LAND p100 Flap
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse GEAR
6. Set FLAP SYSTEM: Choose Flap
NORM: -100% FLAP
MID: 0% FLAP
LAND: 100% FLAP
SPEED 2.0S: SWITCH = FLAP
DX6e, DX8e,
DX6 G2,
DX7 G2,
DX8 G2,
DX9, DX18,
DX20, iX12,
iX20, NX6,
NX8, NX10
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AICRAFT TYPE:
WING: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse GEAR
6. Set FLAP SYSTEM:
SELECT SWITCH D:
POS 0: -100% FLAP
POS 1: 0% FLAP
POS 2: 100% FLAP
SPEED 2.0
When using the recommended 4S 2200mAh battery, the expected flight time
is 3–5 minutes. Actual flight times may vary, based on the condition and per-
formance of the particular battery, flying conditions, and throttle management.
Flight times will typically be longer when using a lower power setting. Set your
flight timer according to your flying style.
When using a compatible Spektrum AirWare equipped transmitter and Smart-
technology receiver along with the installed Smart-technology ESC, real-time
battery voltage telemetry is available to minimize or eliminate the need for a
timer.
See the Integrated ESC Telemetry section of this manual for more informa-
tion.
Smart Technology and Flight Times