User Manual

Receiver Selection and Installation PNP



The recommended receiver for this aircraft is the Spektrum AR631.

If you choose to install a different receiver, it needs to be a 4-channel or more

full range (sport) receiver. Refer to the manual of your chosen receiver for

correct installation and operation instructions.

AR631 Installation

1. Lift the rear of the canopy to remove the canopy from the top of the

fuselage.

2. Attach the appropriate control surfaces to their respective ports on the

receiver using the table at the right.

3. Using double-sided servo tape, mount the receiver to the ﬂat area, as

shown. The receiver should be mounted in the orientation shown, parallel

to the length of the fuselage, with the label facing up and the servo ports

facing the front of the aircraft. The orientation of the receiver is critical for

all AS3X

and SAFE

technology setups.

CAUTION: Incorrect installation of the receiver could cause a crash.

ANTENNA INSTALLATION

The AR631 receiver has a coaxial style antenna. We recommend installing the

antenna as far as possible from metal, batteries, or carbon ﬁber to maximize

signal reception performance.

NOTICE: Do not cut, kink, or modify the antenna. Damage to the coaxial

portion of an antenna will reduce the performance of the antenna.

Shortening or cutting off the 31mm tip will reduce the range.

Active portion

of antenna

AR631 Port Assignments

1 = Throttle

2 = Ailerons

3 = Elevator

4 = Rudder

5 = Retracts

6 = Flaps