User Manual

EN
7
Wing Installation
1. Remove the canopy hatch.
2. Guide the flap, retract and aileron servo connectors (A) through the hole (B)
located in the bottom of the fuselage as shown.
TIP: If needed, use hemostats or pliers to pull the servo connectors into the
fuselage.
3. Plug in the Y-harnesses into the receiver. The single connector side of the
Y-harnesses are marked Ail, Gear, and Flap.
IMPORTANT: The ailerons must be connected to the receiver’s AILE (CH 2)
with a Y-harness (included) for the AS3X
®
system to function properly.
4. Align the wing with the fuselage, and use a 2mm Allen driver to secure it
into position with the included 4 M3 x 26 countersunk machine screws (C).
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
5. Reinstall the canopy hatch on the fuselage.
Disassemble in reverse order.
Assemble the Aircraft
B
C
Ailerons
Retracts
Flaps
A