User Manual

Final Assembly

Required Parts

• Fuselage

• Receiver

• 3-cell 11.1V Li-Po, 16GA

• Hook and loop tape (2)

• Canopy hatch

Required Tools and Adhesives

• Thin CA

Optional Parts

• Hook and loop strap

 1. Check to make sure all servo wires and ESC

wires can reach the location of the receiver before

mounting the receiver. Cut a piece of the hook

and loop tape to the size of the receiver. Install

the receiver using the hook and loop. Plug in

the rudder, elevator, and aileron servos (after

attaching the wing). Route the receiver antenna to

the rear of the plane.

Note: Do not cut the receiver antenna, as

this will greatly reduce the range of the radio

system.

Hint: Position the receiver so the ailerons can be

plugged in easily.