User Manual

6
Required Tools and Adhesives
Tools & Equipment
EFLA257 Screwdriver, #0 Phillips (or included with
EFLA250)
EFLA251 Hex Wrench: 3/32" (or included with
EFLA250)
7mm nut driver
Hobby knife
Paper towel/tissue
Square
Ruler
Felt-tipped pen
String
Adhesives
Medium CA Thick CA
6-Minute Epoxy, 9oz (HAN8000)
Threadlock (for mounting motor to gearbox)
Optional Accessories
EFLA110 Power Meter
EFLA212 Gear Puller: 1mm–5mm Shaft
Other Possible Setups
Optional High Speed Precision Outrunner Setup
EFLM4010A Power 10 Brushless Outrunner Motor,
1100Kv
EFLA312B 40-Amp Brushless ESC (V2)
APC12060E Electric Propeller, 12 x 6E
THP21003SPL 2100mAh 3-Cell 11.1V Li-Po, 16GA
WSD1300 Ultra Plug, Male/Female Set
EFLC3005 Celectra 1–3 Cell Li-Po Charger
This setup is for high speed F3A. It is not recommended
for 3D flying.
Optional High Power 6-Pole Setup (Using Gearbox)
EFLM2005 Six-Series BL 2700Kv Motor (28mm)
EFLM236 400 Gearbox w/56T 0.5M Spur Gear
EFLM1957 19T 0.5 Module 3.2mm ID Pinion Gear
EFLA312B 40-Amp Brushless ESC (V2)
APC12060E Electric Propeller, 12 x 6E
THP21003SPL 2100mAh 3-Cell 11.1V Li-Po, 16GA
WSD1300 Ultra Plug, Male/Female Set
EFLC3005 Celectra 1–3 Cell Li-Po Charger
Using this setup will give you plenty of power for extreme
F3A precision aerobatic flights and 3D aerobatics.