User manual EFL-EFL2375

Available from: www.modelflight.com.au
8. Locate the 4" (102mm) linkage wire. Slide the
“Z” bend into the center hole of the elevator
control horn. Pass the linkage through the
pushrod connector on the ser vo ar m. T ur n on
the radio and plug the elevator ser vo into the
receiver . Center the elevator trim and stick, and
check that the sub-trim (if a programmable
radio)
has been set to 0. Install the ser vo hor n back
onto
the elevator ser vo. Use a 2mm x 4mm screw to
secure the linkage.
9. Repeat Step 7 for the rudder linkage.
23