User manual EFL-EFL2375

Available from: www.modelflight.com.au
Required
Par
ts
Wing
Wing
Pr
eparation
1. Secure a 6" (152mm) ser vo extension
onto
the ser vo lead. Install the aileron ser vo into
the
wing, using the pre-installed string to pull the
6-channel
receiver
Ser vo w/hardware (2)
Ser vo extension, 6" (152mm)
Y -har ness, standard 6" (2)
Control connectors w/backplate (2)
2mm x 4mm screw (2)
4
1
/
4
" (118mm) pushrod wire (2)
Required T ools and Adhesives
Drill
Drill bit: 1/16" (1.5mm)
Screwdriver , #0 Phillips
ser vo lead through the wing. The ser vo lead
will
exit the hole in the top center of the wing. Drill
a 1/16” (1.5mm) hole through the tabs on the
ser vo into the ser vo mount. Be careful not to
drill through the covering in the top of the
wing.
Secure the ser vo using the hardware that was
provided with the ser vo.
24