User manual EFL-EFL2375

Available from: www.modelflight.com.au
2. Drill a 1/16" (1.5mm) hole in the ser vo ar
m
for the pushrod connector . Secure the control
connector in the ser vo ar m using the connector
backplate.
3. Locate the 4
1
/
4
" (118mm) linkage. Place the
“Z” bend into the center hole of the aileron
control horn. Pass the linkage through the
control connector .
4. Plug the aileron ser vo into the receiver . Power
up the transmitter and receiver . Center the
aileron
stick, trim, and any programmed sub-trim values.
Install the ar m on the ser vo so it is parallel to the
aileron hinge line. Use a 2mm x 4mm screw to
secure the linkage.
5. Repeat Steps 1 through 4 for the remaining
aileron ser vo. Then connect a 6" Y -har ness to
the
two 6" ser vo extensions on the ser vos.
25