User Manual

ManualsBrandsE-flite ManualsAirplanesTwin Otter 1.2m PNP, includes Floats

Model Assembly

Landing Gear Installation

1. Loosen the screw on the bottom of the fuselage and remove the landing gear

cover.

2. Loosen the six mounting screws from the landing gear mounting clamps and

set them aside.

3. Press the landing gear into the mounting clamps until it snaps into position.

4. Install the landing gear in the fuselage. Rescrew the six mounting screws in

place.

5. Reinstall the landing gear cover and tighten the fuselage screw.

6. Press the landing gear strut covers (2) onto the wheel struts until they snap

into place.

TIP: Apply a drop of CA to the landing gear strut covers to hold them in place.

Twin Otter 1.2m

Pre ight

SAFE

Select Technology (BNF Basic)

The BNF Basic version of this airplane includes SAFE Select technology which can

offer an extra level of protection in  ight. Use the following instructions to make the

SAFE Select system active and assign it to a switch. When enabled, SAFE Select

prevents the airplane from banking or pitching past predetermined limits, and

automatic self-leveling keeps the airplane  ying in a straight and level attitude when

the aileron, elevator and rudder sticks are at neutral.

SAFE Select is enabled or disabled during the bind process. When the airplane is

bound with SAFE Select enabled, a switch can be assigned to toggle between SAFE

Select mode and AS3X mode. AS3X

technology remains active with no banking

limits or self leveling any time SAFE Select is disabled or OFF.

SAFE Select can be con gured three ways:

• SAFE Select Off: Always in AS3X mode

• SAFE Select On with no switch assigned: Always in SAFE Select mode

• SAFE Select On with a switch assigned: Assigned switch toggles between

SAFE Select mode and AS3X mode

1 Remove and inspect contents.

2 Read this instruction manual thoroughly.

3 Charge the  ight battery.

4 Setup Transmitter using transmitter setup chart.

5 Fully assemble the airplane.

6 Install the  ight battery in the aircraft (once it has been fully charged).

7 Check the Center of Gravity (CG).

8 Bind the aircraft to your transmitter.

9 Make sure linkages move freely.

10 Test the  ap operation.

11 Perform the Control Direction Test with the transmitter.

12 Perform the AS3X Control Direction Test with the aircraft.

13 Adjust  ight controls and transmitter.

14 Perform a radio system Range Test.

15 Find a safe open area to  y.

16 Plan  ight for  ying  eld conditions.