User Manual

Horizontal Tail Installation

1. Slide the horizontal stabilizer into the hole in the vertical tail.

2. Thread the four screws on the underside of the horizontal tail, as shown.

3. Snap the elevator clevis (right) into place, then snap the rudder clevis into place.

4. Snap the horizontal stabilizing  ns into place.

TIP: Apply a drop of CA to the horizontal stabilizing  ns to hold them in place.

Model Assembly Continued

Propeller Installation

1. Determine which spinner and propeller match, then set them aside with the

correct wing half to install as shown. The propeller blades rotate downward on

the fuselage side.

2. Install a propeller adaptor on one of the propeller shafts.

3. Install the left propeller (7056C) on the left propeller adaptor, and install the

right propeller (7056CR) on the right propeller adaptor. Tighten the nut to

secure the propeller in place.

4. Install the spinner and secure it in place with a 2mm x 10mm machine screw.

7056C

7056CR