Manual Addendum

Twin Otter 1.2m

Transmitter Setup (BNF)

If you are using a 6 channel transmitter, the FLAP Channel (CH 6) controls the aps.

Computerized Transmitter Setup

DX6i

1. Go to the SETUP LIST MENU

2. Set MODEL TYPE: ACRO

3. Go to ADJUST LIST MENU

4. Set TRAVEL: FLAPS £-100 100

5. Set FLAPS: Norm -100 Flap Elev 0

LAND £100 Flap Elev 35

Battery Installation and ESC Arming

Battery Selection

Lower the throttle and throttle trim to the lowest settings.

Power on the transmitter, then wait 5 seconds.

Horns Arms

Aileron

Elevator

Rudder

Flaps

The table to the right shows the factory settings for the control horns and servo arms.

These settings, in conjunction with the low rate transmitter settings, are intended for

intermediate level pilots to help ensure a successful ight.

Fly the aircraft at these factory settings before making changes.

Dual Rates and Control Throws

Nose

Wheel

Propeller Installation

WARNING: Do not install the propeller until all system setups are complete.

Failure to heed this warning could result in severe personal injury.

1. Determine which propeller matches each image and install as shown.

2. Install the left propeller (T7056C) on the left propeller adaptor.

Install the right propeller (T7056CR) on the right propeller adaptor.

Tighten each nut to secure each propeller in place.

The nut securing the T7056CR propeller on the right wing is reverse threaded.

3. Install the spinners and secure them in place with a 2mm x 10mm machine screw.

T7056C

T7056CR

tooltip