Manual Addendum

Motor Service

CAUTION: Always disconnect the ight battery before performing

motor service.

Disassembly

1. Remove the spinner screw and spinner from the propeller shaft.

2. Remove the propeller nut. The right propeller nut for prop T7056CR is reverse

rotation.

3. Remove the propeller.

4. Remove the two screws from the sides of the cowling and remove the cowling

from the nacelle.

5. Remove top and bottom set screws.

6. Disconnect the motor wires from the ESC wires.

7. Remove the motor from the X-mount.

Assembly

Assemble in reverse order.

• Correctly align and connect the motor wire colors with the ESC wires.

• Install the propeller as shown.

• Tighten the spinner nut to secure the propeller into place.

T7056C

T7056CR

Float Assembly and Installation

1. Remove the screw on the bottom of the fuselage, and remove the landing gear cover.

2. Loosen the nose wheel assembly screw, and remove the nose wheel assembly from

the nose wheel steering bracket.

3. Loosen the six 2mm x 10mm mounting screws from the landing gear mounting

clamps. Remove the mounting clamps (screws attached) and set them aside.

4. Install the front and rear oat struts in the fuselage. The oat struts angle down at

the ends; the wheel strut is straight out, away from the plane.

5. Reinstall the landing gear cover and tighten the fuselage screw.

6. Install the oats and the spreader bars onto the struts, using the plastic clamps and

the 2mm x 10mm screws to secure each clamp.

7. Install the steering wire, slipping the z-bend into the steering arm and snapping the

rear clip into the water rudder clevis.

8. Secure the pushrod sleeve to the rear spreader bar with the included zip tie.

Tip: If you removed the steering arm for the water rudder for ying with wheels,

reinstall it for ying with oats.

Disassemble in reverse order.

NOTICE: When replacing the wheels with oats, recheck the CG. Place the

battery further forward to compensate for the CG change.