User Manual

EN
Motor Service
13
Post Flight
1 Disconnect the ight battery from the ESC (Required for Safety and battery life).
2 Power OFF the transmitter.
3 Remove the ight battery from the aircraft.
4 Recharge the ight battery.
5 Repair or replace all damaged parts.
6 Store the ight battery apart from the aircraft and monitor the battery charge.
7 Make note of ight conditions and ight plan results, planning for future ights.
CAUTION: Always disconnect the ight battery before performing
motor service.
Disassembly
1. Remove the spinner screw and spinner from the propeller shaft.
2. Remove the propeller nut. The right propeller nut for prop T7056CR is reverse
rotation.
3. Remove the propeller.
4. Remove the two screws from the sides of the cowling and remove the cowling
from the nacelle.
5. Remove top and bottom set screws.
6. Disconnect the motor wires from the ESC wires.
7. Remove the motor from the X-mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Install the propeller as shown.
• Tighten the spinner nut to secure the propeller into place.
T7056C
T7056CR