Pitts S-1S Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni SAFE® Select Technology, Optional Flight Envelope Protection
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support tab for this product.
EN Box Contents Quick Start Information Transmitter Setup Dual Rates Set up your transmitter using the transmitter setup chart Hi Rate Low Rate Ail 18mm 12mm Ele 32mm 24mm Rud 28mm 20mm Center of 86mm +/-3mm back from leading edge of the top wing.
EN SAFE® Select Technology The evolutionary SAFE® Select technology can offer an extra level of protection so you can perform the first flight with confidence. No complex transmitter programming is required. Just follow the simple bind process to make the SAFE Select system active. When activated, bank and pitch limitations keep you from over-controlling and automatic self-leveling makes recovery from risky or confusing attitudes as simple as releasing the sticks.
EN Model Assembly Landing Gear Installation B 1. Install the landing gear assembly (A) into the pocket located at the bottom of the fuselage as shown. A 2. Secure the landing gear into place with the 3 included screws (B) (2 x 10mm self-tapping countersunk screws) as shown. Disassemble in reverse order. Required Adhesives: B Cyanoacrylate-Adhesive (CA) A Horizontal Tail Installation 1. Slide the horizontal tail (A and B) into the slot in the rear of the fuselage. Ensure the control horn faces down.
EN Installing the Wings 1 2 1. Install the bottom wing (leading edge first) and connect the servo connectors from the wing to the servo extension. 2. Secure the bottom wing with the single body clip. IMPORTANT: The bottom wing mounting post is threaded into the fuselage and may need to be adjusted before the body clip can be installed. 3. Install the interplane struts by inserting the curved end into the plastic receptacles on the top of the bottom wing.
EN Transmitter and Receiver Binding / Switching ON and OFF SAFE Select This product requires an approved Spektrum™ DSM2®/DSMX® compatible transmitter. Visit www.bindnfly.com for a complete list of approved transmitters. The aircraft has an optional SAFE Select feature, which can be switched ON or OFF easily by binding in a specific manner as described below.
EN SAFE® Select Switch Designation SAFE® Select technology can be easily assigned to any open switch (2 or 3 position) on your transmitter. With this new feature, you now have the flexibility to enable or disable the technology while in flight. Mode 1 and 2 Transmitters IMPORTANT: Before assigning your desired switch, ensure that the travel for that channel is set at 100% in both directions. Assigning a switch 1. Bind the aircraft correctly to activate SAFE Select.
EN Battery Installation and ESC Arming Battery Selection We recommend the Spektrum™ 2200mAh 11.1V 3S 30C Li-Po battery (SPMX22003S30). Refer to the Optional Parts List for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dimensions and weight of the E-flite Li-Po battery packs to fit in the fuselage. Be sure the model balances at the recommended CG. 5. Insert the battery tray until it clicks into position. 6.
EN Center of Gravity (CG) The CG location is measured from the leading edge of the top wing at the root. This CG location has been determined with the recommended Li-Po battery (SPMX22003S30). TIP: Measure the CG with the aircraft upright. NOTICE: Install the battery but do not arm the ESC while checking the CG. Personal injury may result. 86mm +/- 3mm back from leading edge of top wing. AS3X Control Direction Test This test ensures that the AS3X® control system is functioning properly.
EN Flying Tips and Repairs Consult local laws and ordinances before choosing a flying location. Range Check your Radio System Before you fly, range check the radio system. Refer to your specific transmitter instruction manual for range test information. Oscillation Once the AS3X system is active (after advancing the throttle for the first time), you will normally see the control surfaces react to aircraft movement.
EN Post Flight 1. Disconnect the flight battery from the ESC (Required for Safety and battery life). 2. Power OFF the transmitter. 3. Remove the flight battery from the aircraft. 4. Recharge the flight battery. 5. Repair or replace all damaged parts. 6. Store the flight battery apart from the aircraft and monitor the battery charge. 7. Make note of the flight conditions and flight plan results, planning for future flights.
EN Troubleshooting Guide Problem Possible Cause Throttle not at idle and/or throttle trim too high Aircraft will not Throttle servo travel is lower than 100% respond to throttle but responds to Throttle channel is reversed other controls Motor disconnected from ESC Damaged propeller and spinner, collet or motor Extra propeller noise Propeller is out of balance or extra vibration Prop nut is too loose Flight battery charge is low Propeller installed backwards Reduced flight time or aircraft Flight battery
EN AMA National Model Aircraft Safety Code Effective January 1, 2018 A model aircraft is a non-human-carrying device capable of sustained flight within visual line of sight of the pilot or spotter(s). It may not exceed limitations of this code and is intended exclusively for sport, recreation, education and/or competition.
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase. that you may need any assistance. For questions or assistance, please visit our website at www.horizonhobby.
EN Contact Information Country of Purchase Horizon Hobby Horizon Service Center (Repairs and Repair Requests) United States of America Horizon Product Support (Product Technical Assistance) Sales European Union Horizon Technischer Service Sales: Horizon Hobby GmbH Contact Information servicecenter.horizonhobby.com/RequestForm/ productsupport@horizonhobby.com 877-504-0233 websales@horizonhobby.com 800-338-4639 service@horizonhobby.
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambio Part # | Nummer Numéro | Codice EFL3551 EFL3552 EFL3553 EFL3554 EFL3555 EFL3556 EFL3557 EFL3558 EFL3559 EFL3560 EFL3561 EFL3562 EFL3563 EFL8463 EFL3565 EFL3566 EFL3567 EFL3568 EFL3569 EFLA1140W EFLP11070 SPMSA330 58 Description Beschreibung Descrizione Fusibile verniciato: Pitts 850 mm Aile supérieure peinte : Pitts Ala superiore verniciata: Pitts Painted Top Wing: Pitts 850mm 850 mm 850 mm Painted Bottom Wing: Pitts Aile inférieu
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionali Part # | Nummer Numéro | Codice DYN1400 DYN1405 SPMXC1080 SPMXC1010 SPMXBC100 EFLA250 SPMXCA303 SPMXCA302 SPMX22003S30 EFLB22003S40 EFLB22003S50 SPMX22004S50 SPMX27004S30 SPMR1000 SPMR6655 SPMR6750 SPMR8000 SPMR6775 SPMR8200 SPMR10100 Description “LiPo Charge Protection Bag,Small” “LiPo Charge Protection Bag,Large” Spektrum Smart S1100 AC Charger 1x100W Smart S2100 AC Charger, 2x100W XBC100 Smart LiPo Battery Checker & Servo Driver
© 2020 Horizon Hobby, LLC. E-flite, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, Thrust, Prophet, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
