Pitts S-1S Manual

Pitts S-1S

SAFE

Select technology can be easily assigned to any open switch (2 or 3

position) on your transmitter. With this new feature, you now have the exibility

to enable or disable the technology while in ight.

IMPORTANT: Before assigning your desired switch, ensure that the travel for

that channel is set at 100% in both directions.

Assigning a switch

1. Bind the aircraft correctly to activate SAFE Select. This will allow the

system to be assigned to a switch.

2. Hold both transmitter sticks to the inside bottom corners and toggle the

desired switch 5 times (1 toggle = full up and down) to assign that switch.

The control surfaces of the aircraft will move, indicating the switch has

been selected.

Repeat the process to assign a different switch if desired.

NOTICE: SAFE Select is assignable on any unused Channels 5–9.

100%

3 position Switch

2 position Switch

SAFE

Select Switch Designation

Mode 1 and 2 Transmitters

x 5

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

NOTICE: If control throws are changed from the factory settings, the AR631

gain values may need to be adjusted. Refer to the Spektrum AR631 manual

for adjustment of gain values.

After ying, you may choose to adjust the linkage positions for the desired

control response. See the table to the right.

Control Horn and Servo Arm Settings

Horns Arms

Elevator

Ailerons

Rudder