User Manual

EN
Night Radian FT
Model Assembly Continued
Wing Installation
1. Slide the wing tube (A) into the fuselage.
2. Install the left and right wing over the wing tube.
3. Guide the LED connectors (B) from both wings into the fuse and toward
the bottom hatch.
4. Seat the wings in the slot of the fuselage. Be careful not to pinch any
wires.
5. Secure the wings to the fuselage using the included 2 screws (C) as
shown.
6. Connect the LED connectors to the connector block as shown. The LED
connectors can be in any port of the block.
Disassemble in reverse order.
Control Horn and Servo Arm Settings
A
B
C
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual
for adjustment of gain values.
After  ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Factory
Setting
Horns Arms
Elevator
Rudder
Tuning Horns Arms
More control throw
Less control throw
6