User Manual

Battery Installation and ESC Arming

Battery Selection

We recommend the E- ite

1350mAh 11.1V 30C Li-Po Battery

(EFLB13503S30). Refer to the Optional Parts List for other recommended

batteries. If using a battery other than those listed, the battery should be within

the range of capacity, dimensions and weight of the E- ite Li-Po battery packs

to  t in the fuselage. Be sure the model balances at the recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. Carefully lift the canopy hatch (B) to remove.

3. Install a fully charged battery (C) and secure it into place using the hook an

loop strap (D). See the Adjusting the Center of Gravity instructions for more

information.

4. Connect the battery to the ESC (the ESC is now armed).

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver.

If the ESC sounds a continuous double beep after the  ight battery is

connected, recharge or replace the battery.

5. Reinstall the canopy hatch.

CAUTION: Always

keep hands away from

the propeller. When

armed, the motor will turn

the propeller in response

to any throttle movement.