User Manual

Wing Installation

1. Carefully apply the 2 strips of double-stick tape (A) to the root of the wing as

shown. Assemble the wings on the carbon wing tube (B) so there is no gap. No

epoxy is required to hold the wings together; however, if desired, epoxy may be

used (instead of the tape) to adhere the wings to each other on the wing tube.

2. Ensure the wings are correctly aligned. Using double stick tape, install the front

3. Connect the right and left aileron servo arms to the respective control horns by

using the included linkages and clevises in the outermost holes. Refer to the

clevis adjustment instructions to center the ailerons.

4. Connect the left aileron servo connector to the servo extension labeled “AIL-L”,

and connect the right aileron servo connecter to the servo extension labeled

“AIL-R”.

5. Install the wing on the fuselage.

CAUTION: DO NOT crush or otherwise damage the wiring when attaching

the wing to the fuselage.

6. Install 8 rubber bands (F) on the front and back rods to complete the

installation. Center the wing on the fuselage. Going from front to back over the

wing, attached 8 rubber bands to secure the wing to the fuselage.

7. Disassemble in reverse order.

IMPORTANT: The rubber bands reduce wing damage from impact. Always replace

worn or broken rubber bands.

We recommend removing the wing from the fuselage for transport and storage of

your model. Before each ﬂ ight, ensure the wing is centered, straight and secure on

the fuselage.

TIP: Ensure the caps are secure on the ends of the rods. If needed, apply CA

(cyanoacrylate adhesive) to secure a cap on the rod.

R-AIL

L-AIL