User Manual

EN
Apprentice STS
32
Plane Status LED on the windshield status On-board LED Indication and required action Surface Movement
Tx and Rx are not bound
Flash red and blue in sequence rapidly Flash red and blue in sequence rapidly All surfaces centered
Plane enters bind mode
Flash yellow rapidly Flash red and blue in sequence rapidly All surfaces centered
Bind button AUX1 on Tx is reversed
Flash blue rapidly Flash blue rapidly Elevators move up
Search for GPS lock
Flash purple slowly Flash purple slowly Wags elevator slowly
Virtual Fence indicator; GPS signal if found
and locked, Home location is not set.
Yellow LED fl ashes slowly. Red LED
fl ashes 0-3 times:
0 time-Virtual Fence Off
1 time-Circle Virtual Fence, small
2 times-Circle Virtual Fence, large
3 times-Airfi eld Virtual Fence
Blue LED fl ashes slowly. Red LED fl ashes
0-3 times:
0 time-Virtual Fence Off
1 time-Circle Virtual Fence, small
2 times-Circle Virtual Fence, large
3 times-Airfi eld Virtual Fence
“Wags elevator 4 times rapidly, and then center the
elevator.
Throttle ONLY pulses the motor to taxi to reach location
to set home point.
After set home point, throttle is full range power. “
Compass calibration: if calibration is never
done, plane will enter compass calibration
mode after GPS is locked.
Flash red and blue in sequence slowly
Flash red and blue in sequence slowly
Enter calibration.
Wags ailerons continuously
Home location is set virtual fence modes
are off: Press and hold the bind button for
3 seconds
Green: Beginner mode
Blue: Intermediate mode
Red: Expert mode
Wags all surfaces three times
Beginner Flight Mode: switch position: 0
w/o LAS: solid green
w/ LAS working: solid Green with purple
fl ash every 5 seconds
w/o LAS: solid blue
w/ LAS working: solid blue
Intermediate Flight Mode: switch position: 1
w/o LAS: solid blue
w/LAS working: solid blue with purple
fl ash every 5 seconds
w/o LAS: solid purple
w/LAS working: solid purple
Experienced Flight Mode: switch position: 2
w/o LAS: solid red
w/LAS working: solid red
w/o LAS: solid red
w/LAS working: solid red
Panic mode
Solid green
Solid blue
Plane automatically turns around and
fl ies back to the home location after it
approaches the edge of the virtual fence.
Flashes blue slowly Flashes blue slowly
After the plane fl ies back inside the fence, wags
the plane twice to indicate the control is given
back to the pilot.
Holding Pattern Mode:
Enter: click bind button
Abort: click bind button
Flashes blue slowly Flashes blue slowly
AutoLand Mode:
Enter: Press and hold bind button for 3
seconds
Abort/Exit: click bind button or change fl ight
modes
Flashes blue slowly Flashes blue slowly
Manually turn off GPS after initialization is
done: Press and hold the bind button and
toggle the fl ight mode switch 3 times.
Flashes red slowly Flashes red slowly Wags the plane twice
Loss of signal Flashes red rapidly Flashes red rapidly
GPS is installed backwards/Heading
abnormal/Flight control turns off GPS
Flashes red slowly
Flashes red slowly
Throttle taxi pulse.
LED Indications