User Manual

EN
10
Timber X 1.2m
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR631
gain values may need to be adjusted. Refer to the Spektrum AR631 manual
for adjustment of gain values.
After flying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Factory Setting Horns Arms
Elevator
Elevator
Flaps
Elevator
Flaps
Rudder
Elevator
Flaps
Elevator
Flaps
Aileron
Elevator
Flaps
Elevator
Flaps
Flaps
Elevator
Flaps
Elevator
Flaps
Mode 1 and 2 Transmitters
two or three position switch
x 5
100%
100%
Tuning Horns Arms
More control throw
Less control throw
SAFE
®
Select Switch Designation
SAFE
®
Select technology can be easily assigned to any open switch (2 or 3
position) on your transmitter. With this feature, you have the flexibility to enable
or disable the technology while in flight.
IMPORTANT: Before assigning your desired switch, ensure that the travel
for that channel is set at 100% in both directions and the aileron, elevator,
rudder and throttle are all on high rate with the travel at 100%. Turn throttle
hold OFF if it is programmed in the transmitter.
CAUTION: Keep all body parts well clear of the propeller and any
moving parts and keep the aircraft securely restrained in case of
accidental throttle activation.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the
system to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the
desired switch 5 times (1 toggle = full up and down) to assign that switch.
The control surfaces of the aircraft will move, indicating the switch has
been selected.
Repeat the process to assign a different switch or to deactivate the current
switch if desired.
TIP: SAFE Select is assignable on any unused Channels 5–9.