User Manual

Model Assembly Continued

Slat Installation (Optional)

1. Carefully remove all the foam slat pocket covers (A) from the wing.

2. When the pocket is exposed, carefully apply medium CA to each slat pocket.

3. Mount the slat onto the wing with the rounded edge facing forward. Ensure

that the left and right slats are on the correct wing half. The slat and wing

halves are labeled with “L” and “R” indicators.

Wing Assembly

1. Insert the wing joiner tube and slide the left and right wing halves together,

as shown.

2. Secure the wing together using the wing bracket (A).

3. Guide the ﬂaps, lights and aileron servo connectors (B) into the top of the

fuselage as shown.

Tip: If needed, use hemostats or pliers to pull the servo connectors into the fuselage.

4. Connect the ﬂaps, and aileron connectors to respective Y-harnesses

connected to the receiver. The left and right servos can be connected

to either side of a Y-harness.

IMPORTANT: The ailerons must be connected to the receiver’s aileron

port (channel 2) with a Y-harness (included) for the AS3X

system to

function properly.

5. Connect the two light connectors (with exposed pins) to the light harness.

6. Align the wing with the fuselage and secure into position using the included 2

nylon wing bolts (C).

CAUTION: DO NOT crush or otherwise damage the wiring when

attaching the wing to the fuselage.

Disassemble in reverse order.

Required Adhesives

Medium CA

Lights

Flaps

Ailerons