User Manual

Battery Installation and ESC Arming

Battery Selection

The E-ﬂ ite

2200mAh 14.4V 4S 30C Li-Po battery (EFLM22004s30) is

recommended. The EFL22003S30 battery may also be used. For maximum

performance with 3 cells, a 13X6.5 electric propeller may be utilized. Refer to the

Optional Parts List for other recommended batteries. If using a battery other than

those listed, the battery should be within the range of capacity, dimensions and

weight of the E-ﬂ ite Li-Po battery packs to ﬁ t in the fuselage. Be sure the model

balances at the recommended CG before ﬂ ying.

CAUTION: Always keep hands away from the propeller. When armed,

the motor will turn the propeller in response to any throttle movement.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

transmitter, then wait 5 seconds.

2. For added security, apply the loop side (soft side) of the optional hook and loop

tape (A) to the bottom of your battery, and the hook side to the battery tray.

3. Press the latch button (B) and remove the battery hatch.

4. Install the fully charged battery (C) in the center of the battery compartmant

as shown. Secure using the hook and loop straps (D).

5. Connect the battery to the ESC (the ESC is now armed).

6. Keep the aircraft immobile and away from wind or the system will not initialize.

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver when it is initialized

If the ESC sounds a continuous double beep after the ﬂ ight battery is

connected, recharge or replace the battery.

7. Reinstall the battery hatch.