User Manual

EN
11
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636 gain
values may need to be adjusted. Refer to the Spektrum AR636 manual for adjust-
ment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired control
response. See the table to the right.
Tuning Horns Arms
More control throw
Less control throw
Control Horn and Servo Arm Settings
Factory Setting Horns Arms
Elevator NA NA
Rudder
Aileron
Flaps
Control Surface Direction
Switch on the transmitter and connect the battery. Use the transmitter to operate
the aileron, elevator, and rudder controls. View the aircraft from the rear when
checking the control directions.
Ailerons
1. Move the aileron stick to the left. The right aileron should move down and the
left aileron up, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and the
left aileron down, which will cause the aircraft to bank right.
Aileron stick
Rudder stick
Elevator stick
Elevators
3. Pull the elevator stick back. The elevators should move up, which will cause
the aircraft to pitch up.
4. Push the elevator stick forward. The elevators should move down, which will
cause the aircraft to pitch down.
Rudder
5. Move the rudder stick to the left. The rudder and the nose wheel should move
to the left, which will cause the aircraft to yaw left.
6. Move the rudder stick to the right. The rudder and the nose wheel should
move to the right, which will cause the aircraft to yaw right.